Screw air compressor is a more used equipment in the production process of modern enterprises, which is of great significance to stabilizing enterprise production. As we all know, air compressors rely on compressed air to provide power for enterprise production, because compressed air contains a large amount of moisture, oil, dust and other pollutants, which will cause certain damage to the equipment and affect the reliability of the equipment. Therefore, when using air compressors, they are often equipped with precision filters.
The main function of precision filters is to remove pollutants in compressed air, so that the compressed gas can meet the production requirements of enterprises. So, what problems do you need to pay attention to when installing precision filters? The following small editor will summarize for you:
1. If there are multiple precision filters in the compressed air system, the filter with coarser precision should be installed close to the air source side, and the higher precision should be installed on the air side, that is, "coarse first and then fine";
2. Pay attention to the direction during installation, and determine the inlet and outlet positions according to the direction indicated by the shell arrow to ensure that the inlet and outlet directions of the installed filters are determined;
3. The installation of the filter should be maintained at a certain height to facilitate the replacement of the filter element in the future;
4. The pipeline filter should be installed vertically on the ground, and there should be sufficient drainage height below;
5. There should be no high-temperature heat source and toxic and corrosive gases near the filter use environment;
6. The filter housing is a pressurized container, which should avoid knocking and collision during installation, and the sealing connection should be reliable to prevent gas leakage;
7. There should be a globe valve and a bypass valve in the filter inlet and outlet pipeline to facilitate maintenance and replacement of the filter;
8. When the weather is cold, the fluid in the shell should be drained before using the filter.
