Clean heat dissipation of the air compressor

Every 2000h or so of the operation of the air compressor, in order to remove the dust on the heat dissipation surface, it is necessary to open the cooler purge hole cover on the fan bracket, and use a dust blowing air gun to purge the cooler until the dust on the heat dissipation surface is clean. If the heat dissipation surface is seriously dirty and difficult to purge clean, the cooler can be removed, the oil in the cooler can be poured out and the four inlets and outlets are closed to prevent dirt from entering, and then the dust on both sides is blown off with compressed air or rinsed with water, and finally the water stains on the surface are dried. Put it back in place [3].
Remember! Do not scrape the dirt with hard objects such as iron brushes to avoid damaging the surface of the radiator.